Symptoms anty-lock brake system accelerometer Diagnostic Steps Performed/Parts Replaced abs motor Details of Question lap belts Best Answer.
P0301-P0310: CYL misfire Last 2 digits of the code indicate effected CYL Code sets when more than 1.8% misfire rate is measured during.
P1686-no skim BUS messages Code sets when no skim messages are received over PCI BUS. Monitored with Key on. Possible causes: PCI BUS.
If passlock sensor, BCM or PCM/VCM has been replaced, perform passlock relearn procedure.PCM/VCM & BCM must learn their own configuration.
DTC will set if following conditions MET for less than 1 second: ignition switch in crank or run position, system voltage greater than 5.
Symptoms hjghg Diagnostic Steps Performed/Parts Replaced jhgjhg Details of Question jhg Best Answer gfdgfd What fixed the problem.
Symptoms car will not hold idle even when commanded with scan tool Diagnostic Steps Performed/Parts Replaced compression test and smoke.
Complaint The customer states the check engine light is on and the vehicle is misfiring. Cause Connected a scan tool to vehicle and found.
United States Tren
- 1. UConn 7,523 posts
- 2. #WWENXT 17.3K posts
- 3. Boogie Fland N/A
- 4. Slept 20.1K posts
- 5. Danity Kane 1,645 posts
- 6. Scottie Barnes 2,425 posts
- 7. Lamar Wilkerson 1,431 posts
- 8. Raptors 11.2K posts
- 9. #MerryChristmasJustin 2,363 posts
- 10. Aundrea N/A
- 11. #RHOSLC 4,334 posts
- 12. Cale Makar N/A
- 13. Todd Golden N/A
- 14. Jalen Brunson 3,506 posts
- 15. MSPs 2,111 posts
- 16. Xaivian Lee N/A
- 17. Malachi Smith N/A
- 18. Oilers 3,289 posts
- 19. #iubb 1,652 posts
- 20. #BTCCBestCEX 1,304 posts
Something went wrong.
Something went wrong.