Ssssssssssssssssssssssssssss sssssssssssssssssssssssssssssssssssssss
Symptoms anty-lock brake system accelerometer Diagnostic Steps Performed/Parts Replaced abs motor Details of Question lap belts Best Answer.
P0301-P0310: CYL misfire Last 2 digits of the code indicate effected CYL Code sets when more than 1.8% misfire rate is measured during.
P1686-no skim BUS messages Code sets when no skim messages are received over PCI BUS. Monitored with Key on. Possible causes: PCI BUS.
If passlock sensor, BCM or PCM/VCM has been replaced, perform passlock relearn procedure.PCM/VCM & BCM must learn their own configuration.
DTC will set if following conditions MET for less than 1 second: ignition switch in crank or run position, system voltage greater than 5.
Symptoms hjghg Diagnostic Steps Performed/Parts Replaced jhgjhg Details of Question jhg Best Answer gfdgfd What fixed the problem.
Symptoms car will not hold idle even when commanded with scan tool Diagnostic Steps Performed/Parts Replaced compression test and smoke.
Complaint The customer states the check engine light is on and the vehicle is misfiring. Cause Connected a scan tool to vehicle and found.
United States Trends
- 1. #PercyJackson 9,547 posts
- 2. annabeth 6,368 posts
- 3. grover 2,668 posts
- 4. #MerryChristmasJustin 5,495 posts
- 5. clarisse N/A
- 6. Slept 20.3K posts
- 7. Immanuel 2,251 posts
- 8. Danity Kane 2,693 posts
- 9. #bb27 1,096 posts
- 10. Bicycle 5,383 posts
- 11. UConn 7,917 posts
- 12. Aundrea 1,190 posts
- 13. Keanu 2,962 posts
- 14. Gowdy 5,982 posts
- 15. Oslo 233K posts
- 16. #WWENXT 18.9K posts
- 17. #PokemonLegendsZA 56.9K posts
- 18. Marlon 14K posts
- 19. Eileen Higgins 33.4K posts
- 20. Scottie Barnes 2,279 posts
Something went wrong.
Something went wrong.